[Guide] Using CH341A-based programmer to flash SPI EEPROM

Ok, I’m almost ready to order. The 2nd one seem to have a picture with pinout:

http://i.ebayimg.com/00/s/MzM4WDUwNg==/z…FUs43F/$_12.JPG

But I don’t think it’s what you mentioned. Either way, I would need a SOIC16 clip for that which I don’t need to buy right now.

The first one has a led too. Unless the 2nd one can be used for 16-pin (highly doubt it), I’ll order the 1st one + SOIC8 clip.

The SOIC8 clip ebay listing also has a “10 PCs PCB Convertor” but this is useless for me if I understand properly.