Last time I made a post here in early August, I was complaining about shoddy connection and general issues with an AliExpress bios clip, and after some advice I was left with a different type of bios connector called “Pomona 5250” that I bought from eBay, some jumper cables, and zero clue how to wire it use to my ch341 programmer. I tried obvious ways, lining the wires up parallel to the chip, reverse order, staggered, but when I plug it in- nothing? Is there a wiring guide or someone who knows how to wire this up or am I screwed, or some basic advice? I got a lot of motherboards to flash so…
Its on the guides that i linked back in Aug 10
lining the wires up parallel to the chip, reverse order, staggered, but when I plug it in- nothing?
Its nothing like that… we must know the target SPI pin assignment and correctly bridge them in the CH341A
SPI IC pin out examples (NOT general rule on all kind of ICs)
That’s weird, I guess I didn’t understand the guides initially and skimmed over them… Thanks for the help on everything