Hello guys
I had been talking to the very kind @Lost_N_BIOS regarding this. Literally has spoon-fed me each step. . Really grateful for this patience.
But since is out of forum since a week or so, I’m trying to put my problem in the forum if someone can help me.
Background:
Acer VN7-591G, purchased on a resell, turns off exactly at 30mins on each boot. After reading about it for a week or so, got to know about BIOS and its regions. (ME region version isnt detected by Intel Detection tool - ME FW version - Unknown. HWinfo doesnt show Intel ME tab) Talked to @Lost_N_BIOS , as my programmer was being shipped, tried to go for pinmod first but datasheet for my realtek chip wasnt available, so had to skip it.
After receiving the programmer, had taken the backup of the BIOS.
Chip ID - Micron 25Q064A.
Software - CH341a programmer v1.34. (But it detects it as 25Q64A - problem?)
ME Analyzer of BIOS Attached.
Here is the dump - https://drive.google.com/open?id=12R_LzI…lnJwsr3C6ytuwee
Current:
Since @Lost_N_BIOS has been away from forums, I tried a few things on my own
1. I tried to follow Clean ME thread by Plutomaniac and create a BIOS to write using the programmer.
Here is the .bin file - https://drive.google.com/open?id=1Dr7kzX…wy0XUHhegGDcDgY
2. I also tried ME Injector (https://github.com/kolyandex/Intel-ME-re…jector/releases) to create a new BIOS and write that as well
Here is the .bin file - https://drive.google.com/open?id=12xvtzd…PyPNzJctOb4l2IV
I used CH341a programmer v1.34 to erase and write the above bios. (@Lost_N_BIOS had asked to use ASprogrammer 1.41 - but it doesnt detect the chip, help for this)
Writing using CH341a programmer v1.34 was successful but when I turned on the laptop, all of the problems are same, laptop still shuts down in 30 mins and Intel detection tool doesnt detect ME firmware or any of its detail, HWinfo doesnt show Intel ME tab as well.
However I also saw the following in Device manager with a yellow triangle on it:
Intel(R) Management Engine Interface
Driver version: 11.0.5.1189
(low quality picture attached)
PLEASE HELP!!! IM SO ANNOYED WITH THIS 30 MINUTES SHUTDOWN
Could it happen that the BIOS chip has some write protection even though CH314A programmer 1.34 says its successfully written and even verified?
Hi Raj
Thanks for replying. I'm at work and I ll reprogramme with the attached after I get back. But could you tell what went wrong?
And which programmer should I use? ASprogrammer 1.41 or Default CH314A programmer v1.34?
The Chip ID is Micron 25Q064A.
But Programmer v1.34 detects it as 25Q64A, is that a problem?
Please note I had done a mistake in typing in my post above (edited now) - The Chip ID is 25Q064A
Thanks for replying. I'm at work and I ll reprogramme with the attached after I get back. But could you tell what went wrong?
And which programmer should I use? ASprogrammer 1.41 or Default CH314A programmer v1.34?
The Chip ID is Micron 25Q064A.
But Programmer v1.34 detects it as 25Q64A, is that a problem?
Please note I had done a mistake in typing in my post above (edited now) - The Chip ID is 25Q064A
Please reprogramme bios…
Hi Raj
Thanks for replying. I’m at work and I ll reprogramme with the attached after I get back. But could you tell what went wrong?
And which programmer should I use? ASprogrammer 1.41 or Default CH314A programmer v1.34?
The Chip ID is Micron 25Q064A.
But Programmer v1.34 detects it as 25Q64A, is that a problem?
Please note I had done a mistake in typing in my post above (edited now) - The Chip ID is 25Q064A
All time use latest bios from website .
Then success…
Sorry for bad language
All time use latest bios from website .
Then success…
Sorry for bad language
Okay understood.
I was using the BIOS dump from the programmer.
Thanks again